Easyprox - Stand Alone Solution

No wires, no mess, a stand alone access control solution that only requires a door handle to be replaced. Suitable throughout a site for as many doors as required, Easyprox compact is an all-in-one battery powered lock system that is ideal for internal doors. All doors can use the same fobs and installing the system is easy because it's not wired into a mains power source. Easyprox compact can be installed by any competent locksmith as required.

• Battery powered access control
• Easy to install
• Forced entry prevented by anti-shim plunger
• Battery life up to five years (Spare battery packs available)
• Up to 10,000 users
• Low battery warning
• Cards are immediately valid
• Lost cards can quickly be deleted

Use the template provided to fit the door latch. Cut the square drive to length and slide into the latch. Fit battery and connect to the unit. The unit will start to beep. Present the enrolment card to the unit. Fit the front and rear lock assembly to the door and secure the two parts of the lock together with the fixing screws. Close the door and mark the top and bottom of the latch where it touches the frame. Mark the correct position and fit the strike plate.

Easyprox Latch Template

Easyprox Installation Guide

User cards or fobs are valid and ready for use as soon as installation is complete. Every card or fob is supplied with a corresponding shadow card. As they are issued, the name of the user is marked on the shadow card. If someone is to be removed or loses thier card, the shadow card marked with that persons name is presented to all readers on site. This action invalidates the card or fob. Another card or fob may then be issued for that user.